NAS Driveway Alert Wireless Distance 500m From The Beams To The 4 Zone Indoor Alert (DW-N84B500M)

$222.00
DW-N84B500M
In stock
+

The 4 Zone Indoor Alerts purpose is to show which zone has activated. Sets of Solar Beams can be set up in different zoned areas.  The zone that has detected an intrusion will be displayed on the 4 Zone Indoor Alert.

Applications- Driveway Alarm, Business Entrance Alert, Perimeter Fencing Alarm, Swimming Pool Alarm. Made for the Australian environment.

The installation is simple and easy, turn the Solar Beams on, mount them and plug in the 4 Zone Indoor Alert. No programming required. 

No cabling required and no replacing batteries, the waterproof solar beams require outdoor light and the Indoor Chime requires a power point.

4 Zone Indoor Alert

4 Zone Indoor Alert (RV-DWR84)
• Fully Expandable System 
• 4 Zones (Areas) Paired With One,Two,Three or Four Solar Sensors, positioned for example across the front door, back fence, patio, & garage. These Areas (Zones) Will Show on the 4 Zone Indoor Alert if one area picks up movement.
• Several 4 Zone Indoor Alerts can be Paired to the Solar Sensors Each Having a Different Chime.
• Plugs Directly into a Power Point Requires 240V Power
• 35 Different Chimes
• 4 Volume Levels
• Not Waterproof - indoors only
• 2 Year Warranty


Infra- Red Solar Beams

Solar Beams 500M Wireless Distance (DW-B500M)
• The Waterproof Solar Beams can be mounted 60m apart spanning across a driveway or along a fence line. 
• The Solar Beams can be mounted clear-line of sight up to 500M from the Indoor Chime. 
• The Solar Beams have two infra-red sensors that need to be broken at the same time to wirelessly alert the Indoor Chime, this prevents false alarms.
• On a Driveway the Solar Beams are best mounted 900mm from the ground to the middle of the two infra-red sensor on the Solar Beams, this will prevent false alarms.
• Having to break the 2 infra-red sensors beams eliminates false alarms from livestock, dogs & vermin.
• The Solar Beams have advanced photoelectric technology so that bad weather will not cause false alarms.
• The Solar Beams are self-powered by solar rechargeable lithium ion batteries and they only require light to recharge not full sun.  They will charge on cloudy overcast days. 
• If there is no natural light, the built in batteries can support up to approx. 3 days of moderate use. The Solar Beams can be installed inside but they will require mains power. 
• The solar battery life is approx. 3 years or more, batteries can be replaced.
• Working Voltage 3.3V
• Solar output current ≥ 4mA at an Illumination level of 1800Lx
• Note that outdoor Illumination on raining days is approx. Level of  2000Lx
• Maximum alarm/alerting times in 24 hours is ≥ 50 times
• 2 Year Warranty

 

 

Driveway Alert Solar Beams Range 500m Measurements

 

  • Small Animals or Leaves will not activate the Solar Beam Sensors because they cannot block both of the infra-red beams at the same time.
  • Extremely reliable in all weather conditions

 

 

Installation Guide

  • The Solar Beams Have Been Tested & Programmed to the Alert/Chime Before Sending.
  • NO PROGRAMMING is Required Just Installation.
  • DO NOT Continually Test the Beams indoors.
  • DO NOT test the Beams in short periods of time as this could impend the battery life and cause the beams to malfunction.

 

TURN ON THE SOLAR BEAMS

1. Press the white buttons on the back of each beam once, the buttons will illuminate. Each Solar Beam will take approx. 5-10 seconds to start up. 

2. Install and line up the infra-red sensors on the beams. To line up the infra-red sensors observe the ON button on the Receiver Beam (R) only, this will remain illuminated until it is in lined with the (T) Beam, once it is in-line it will blink, this blinking will continue for approx. 10 seconds and then it will rapidly blink and turn off. The beams are now active.

3. Then power up the Indoor Security Alert and test.

 

Installation Precautions How Not to Install Beams

 

1. Never install the beams on an angle.
2. Ensure there is not an obstacle between the beams as this hinder the transmission.

 

3. When installing multiple beams install as above so that the beams wireless transmissions do not interfere with each other.

 

 4.  Ensure that the Solar Panel is exposed to direct sunlight, do not have the infra-red lights facing direct sun light.
 5.  High-Voltage towers may interfere with the wireless signal.

Damage resulting from failure by improper use or failure to observe the precautions stated above will not be covered by the warranty period.

This driveway alert will not false alarm if it has been installed correctly.  The driveway alert will false alarm if the beams have been knocked out of alignment.

Damage resulting from failure by improper use or failure to observe the precautions stated above will not be covered by the warranty period.

This driveway alert will not false alarm if it has been installed correctly.  The driveway alert will false alarm if the beams have been knocked out of alignment.